Peumatic Grouting pump is designed for strain and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the free rock mass. The maximum grain measurement can not exceed 0.2 mm.
Grouting pump operation and maintenance is straightforward, protected and dependable. This pump is utilized in mines operating underneath troublesome situations as a outcome of it’s dependable and explosion-proof.
Basic Pneumatic Grouting pump embrace: An air inlet, the pneumatic cylinder, mounting base body and stand, pressure gauge, pumping cylinder, outlet with quick release coupling and wheels.
How it actually works
Pneumatic stress in the air cylinder exerts a excessive strain on the grout combination which outcomes in ejection of grout with a high pressure and velocity. The valves of the air cylinder in the pump operate mechanically to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to finish the pumping cycle.
Pneumatic grout pump can be driven even with out Electrical power supply in distant areas by using engine driven compressor.
The pump is majorly utilized in building and mining business for injecting materials into extensive and medium dimension hole in beams, columns ,basement partitions and flooring, carry shaft concrete wall fill-up and so on. In mining trade it is used to fill up cement answer where there’s a hole exists between structure and rock and for soil stabilization.
Detachable design tends to simple upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is widely used in tunnels, coal mine, bridges and dams, building basis, and other underground projects, and inflammable, explosive websites and different bad environment.
เกจแรงดันลม has application in chemical business additionally to pump out chemical slurries.
The pump is electricity free so, can be utilized at any site condition whether or not it’s rural or city.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment vary. Generally the final amount of the grouting quantity is 8 or10 instances of the quantity to begin with. And the ultimate grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specially designed for high-pressure grouting. And it adopts full hydraulic drive, it’s pressure and flow can be adjusted based on the requirements of grouting,(The flow of grouting pump is 0-100L/min, strain of discharge is 0-10MPa).apart from, This Pneumatic high-pressure grouting pump can be utilized for grouting single or double fluid.
High-pressure grouting pump is mainly used for highways, railways, water and electrical energy, building, mining and so forth. ground/underground building.
Mining Pneumatic Grouting pump has the advantages of low power consumption, small vibration, low noise, small size, high efficiency, dependable performance, strain and circulate control, long life and so forth. Common mine grouting pump has pneumatic injection pump, twin fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump is also Light weight and with a wheelie design it might be carried simply. It is designed for simple operation and low upkeep. Last however not least its spare components are simply obtainable.